Cadillac 1999 Eldorado Owner's Manual page 110

3. Using both hands, press the hand
button and the desired button on the Universal
Transmitter. Continue to press both buttons
through Step 4.
4. Hold down both buttons until you see the indicator
light on the Universal Transmitter flash slowly and
then rapidly. The rapid flashing indicates that the
Universal Transmitter has been programmed.
Release both buttons once the indicator light starts
to flash rapidly.
If you have trouble programming the Universal
Transmitter, make sure that you have followed the
directions exactly as described. The Universal
Transmitter may not work with older garage door
openers that do not meet current Federal Consumer
Safety Standards. If you cannot program the transmitter
after repeated attempts, refer to "Rolling Code
Programming" later in this section or contact the
Universal Transmitter manufacturer at 1
Be sure to keep the original hand
in case you need to erase and reprogram the
Universal Transmitter.
2-54
-
held transmitter
- - -
800 355 3515.
-
held transmitter
Note to Canadian Owners: During programming, the
-
hand held transmitter may automatically stop
transmitting after one or two seconds. In this case, you
-
should press and re press the button on the hand
transmitter every two seconds without ever releasing the
button on the Universal Transmitter. Release both
buttons when the indicator light on the Universal
Transmitter begins to flash rapidly.
Operating the Universal Transmitter
Press and release the appropriate button on the Universal
Transmitter. The indicator light comes on while the
signal is being transmitted.
The Universal Transmitter is disabled when the VALET
lockout button inside the glove box is activated. For
more information, see "Valet Lockout Button" in
the Index.
-
If the hand held transmitter appears to program the
Universal Transmitter but does not open your garage
door, and if the garage door opener was manufactured
after 1996, the garage door opener may have a "rolling
code" system. A rolling code system changes the code
of the garage door opener every time you open or close
the garage door.
yellowblue
-
held