Cadillac 1998 Seville Owner's Manual page 120

Training a Garage Door Opener with
"Rolling Codes" (If Equipped)
If you have not previously programmed the hand-held
transmitter to the universal transmitter, see
"Programming the Transmitter" in the Index. If you
have completed this programming, you need to train the
garage door opener receiver to recognize the universal
transmitter. Refer to your garage door opener owner's
manual for the proper transmitter training procedure for
your garage door opener brand.
1.
2.
3.
Locate the training button on the garage door opener
receiver. The exact location and color of the button
may vary by garage door opener brand. If you have
difficulty locating the training button, refer to your
garage door opener manual.
Press the training button on the garage door opener
receiver for one or two seconds. A light indicator will
begin to flash when the receiver enters the train mode.
Return to the universal transmitter in your vehicle
and press the universal transmitter button you have
already programmed for two to three seconds. Press
the button again to make sure that the universal
transmitter has been trained to the garage door
opener receiver. Check that the train was successful.
The receiver light should no longer be flashing.
The garage door opener should now recognize the
universal transmitter. You may either use the universal
transmitter
or
the hand-held transmitter to open the
garage door.
If after following these instructions you still have
problems training the garage door opener, consult
your dealer.
Erasing Chan--
To erase all three programmed channels, hold down the
two outside buttons until the red light begins to flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
-
Accessories
Accessories for the universal transmitter are available
from the manufacturer of the unit. If you would like
additional information, please call 1-800-355-35 15.
2-59