HoMedics enviraScape MARIPOSA Instruction Manual And Warranty Information page 3

CAUTION CONTINUED
• The electrical cord of this product cannot be replaced. If it
sustains damage, you must stop using this product immedi-
ately and return it to the HoMedics Service Center for repair.
(See the warranty section for HoMedics address.)
• Disconnect the appliance from outlet before putting hands
into water.
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is con-
trolled by the switch located at the front of the pump. The
speed is indicated by a plus (+) and minus (-) sign. To
increase the speed, move the switch slowly downward in
the direction of the plus sign. You will hear a click as the
switch moves to each speed level. At its highest speed level,
the switch will cease to move any further. To decrease the
pump speed, move the switch upward toward the minus
sign. Similarly, at its lowest speed, the switch will cease to
move any further (Fig 11). NOTE: It is recommended the
pump be set at its highest speed during assembly and later
adjusted to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
Figure 1
Stones
Small Leaf
Middle Leaf
Large Leaf
PVC Tube
Slot
Slot
Waterproof
Leg
Light
Leg Watermark
Pump
Pump Outlet
Slot
Base
Power Cord
Cord Slot
Switch
Adaptor
4
Figure 2
3. Lead the cord through the cord slot on
the bottom of the base. This will
ensure that the unit is balanced when
Plastic
Light Tube
placed on a flat surface. Attach the
Water Supply
A/C adaptor jack to the base power
Waterproof Light
Tube
Pump cord. DO NOT plug into outlet at this
PVC Tube
time (Fig. 1).
4. Slide the small waterproof light
attached at the pump into the rubber
plug of the plastic light tube at the
underside of large leaf (Fig.2).
5. Connect the PVC tube over the
Figure 3 water supply tube located at the
underside of large leaf, then insert
the small end of the PVC tube into
Slot
Mark on the pump outlet (Fig. 2).
Large
Leaf 6. Attach the three legs to the slots
Slot
located at the underside of the large
leaf. Insert other end of leg into slot
Leg
located inside of base.
Mark on
Edge of
Align the mark " "at the underside of
Base
Slot
large leaf with the mark " " at the
edge of base (Fig. 3).
NOTE: Only one leg requires slot,
other two legs sit flush on
bottom surface of base.
Figure 4
7. Place middle leaf on pillar of large leaf,
then place small leaf on top (Fig. 4).
Small
8. Add approx. 33oz clean water into
Leaf
the base. The water level should be
even with the watermark. Place
Middle
stones on the large, middle, small
Leaf
leaf and base for decoration (Fig. 5).
NOTE: To achieve the best water
Pillar
Large
movement, adjust middle and small
Leaf
leaf by rotating slightly.
9. Plug the cord into 120V household
outlet. The fountain is controlled by the
switch located on the power cord. If
pump doesn't operate, rotate in-line
switch once to turn "on" and once more
Figure 5 Figure 6
to turn "off". NOTE: Ensure that the
Stones electrical cord loops below the electrical
outlet to form a 'Drip Loop' (Fig. 6). This
will prevent water from running down
the cord into the electrical outlet.
Water
Watermark
Drip
Loop
5