Door Swing Reversal (Optional) - Crosley Conservator User & Care Manual

Door Swing Reversal (Optional)

The refrigerator is shipped with the doors opening from left to right. To reverse the
door swing to open from right to left, perform the steps in the following procedure.
Tools Required (Not Included) :
10mm and 8mm box end or socket
wrench, Phillips screwdriver, flat blade
screwdriver
WARNING
Before reversing door, be sure
to unplug the freezer. Failure to
unplug may result in serious injury
or death from electric shock.
CAUTION
To avoid personal injury and
property damage, obtain
assistance from another person to
perform door reversal. Also, before
door reversal, remove shelves, bins
and food from refrigerator.
NOTICE: The following procedure as
described may differ in certain details
from actions required to reverse the door
swing.
1 Remove the screws attaching the top
hinge cover to the cabinet right top
corner. Raise cover and detach wire
harness from door light switch within
cover. Remove top hinge cover. Use a
10mm box end or socket wrench to
remove the screws attaching top hinge
to cabinet. Remove top hinge. Remove
screw attaching rectangular cover
to cabinet left top corner. Remove
rectangular cover.
10mm
2 Open door being careful not to let it
fall down. With the aid of an assistant
lift door straight up to remove it from
bottom hinge. Place door on a non-
scratching surface.
3
With aid of assistant, carefully tilt
unit onto its back to lay on the floor.
Unscrew and remove leveling leg from
bottom left corner of cabinet. Use
an 8mm box end or socket wrench
to loosen screws attaching bottom
hinge to cabinet bottom right corner.
Remove bottom hinge. Remove hinge
pin and washer from right side of
hinge and reinsert into hole in hinge
left side. Use removed screws to attach
hinge to cabinet bottom left corner.
Screw previously removed leveling
leg into place on cabinet bottom right
corner. With aid of assistant, raise unit
back to upright position.
9
Washer