Page 2
The WIM shall only be installed and serviced by qualified and trained personnel. • The WIM can be powered from a low power, Class 2 power supply, in compliance with local regulations. • To be sure of safety, do not modify or add anything other than mentioned in this manual or indicated by •...
Page 3
WIM | QUICK REFERENCE GUIDE CONNECTIONS Front side RS485 WIEGAND connection output indications connection RS485 Connect the RS485 to the License Plate Reader (9600, 8N1). RS485-B (green) RS485-A (yellow) GND: RS485-GND (purple) Wiegand Connect the Wiegand output to your access control system.
Page 4
WIM | QUICK REFERENCE GUIDE Rear side Switches Power input Power input Use the supplied 24VDC power adapter. Power supplies must be able to supply 12 – 24 VDC / 5 Watt (positive voltage at center pin). Switches Plate conversion mode switches.