WIPER BLADE REPLACEMENT
To
replace the entire wiper blade, follow these steps:
1. Position the windshield wipers on the windshield in the "mid" wipe
position. To do this, turn the ignition key to ACCESSORY and turn
the wipers on. Then with the door open, turn the ignition key to OFE
"I
I
1
2. Insert the tip of a small screwdriver into the slot as shown and gently
press down to release the wiper blade from the arm.
3. To
install the wiper blade, align the wiper arm pin with the hole on the
wiper blade assembly and snap it into place. Return the wipers to their
normal position.
If
you only want to replace the wiper insert, follow these steps:
1. Position the windshield wipers on the windshield in the "mid" wipe
position. To do this, turn the ignition key to ACCESSORY and turn
the wipers on. Then with the door open, turn the ignition key to OFF.
2. Insert the tip of a small screwdriver into the slot as shown and gently
3. Insert
a
small coin between the edge of the blade housing and the
press down to release the wiper blade from the arm.
rubber blade insert.
4. Carefully apply pressure until the insert clears one side of the housing tabs.
5.
Now pull the insert from the blade housing.
6-4 1