Dismantling The Chain Brake - Husqvarna 536 Li XP Workshop Manual

9.16 Dismantling the chain brake

WARNING!
Exercise care to ensure the springs
do not fly out and causes personal
injury. Wear protective goggles!
1
Dismantle the drive wheel cover, saw chain and
bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
2
Dismantle the motor.
See "Dismantling the motor".
3
Unplug the connectors and put aside the cable
covering the chain brake.
4
Loosen the screws (3x) and remove the cover.
See figure 33.
5
Catch the large spring (A) with a screwdriver and
lift it out.
See figure 34.
6
Remove the spring and shaft (B) followed by the
catch (C).
See figure 35.
Cleaning and inspection
• Clean and inspect all parts of the chain brake.
Components must always be replaced with
new ones if cracked or showing signs of other
defects. Always use original spare parts.
See figure 36.
Fig 33
A
Fig 34
Fig 35
Fig 36
Repair Instructions
B
C
37
English –