Connecting the TV
Cable System or
VHF/UHF Antenna
System
Cable System and
VHF/UHF Antenna
System
You can enjoy high-definition and standard-definition digital programming
(if available in your area) along with standard-definition analog
programming.
This TV is capable of receiving unscrambled digital programming for
both cable (QAM and 8VSB) and external VHF/UHF antenna (ATSC).
It is strongly recommended that you connect the CABLE/ANTENNA
input using a 75-ohm coaxial cable to receive optimum picture quality. A
300-ohm twin lead cable can be easily affected by radio frequency
interference, resulting in signal degradation.
Cable or VHF/UHF (or VHF only)
75-ohm coaxial cable
Use an optional A-B RF switch (not supplied) to switch between the cable
and over-the-air antenna programming, as indicated below.
Cable
Antenna
Be sure to set the Cable setting to On or Off in the Channel settings for
the type of input signal you choose (see page 31).
Rear of TV
CABLE/ANTENNA
A/B
RF Switch
A
B
CABLE/ANTENNA
Getting Started
Rear of TV
13