Cisco Catalyst IE 3 00 Series Installation Manual page 2

Warnings
Warning
Before performing any of the following procedures, ensure that power is removed from the DCcircuit. Statement
1003
Warning
Read the installation instructions before you connect the system to its power source. Statement 1004
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement1017
Warning This equipment is supplied as "open type" equipment. It must be mounted within an enclosure that is suitably
designed for those specific environmental conditions that will be present and appropriately designed to prevent
personal injury resulting from accessibility to live parts. The interior of the enclosure must be accessible only
by the use of a tool.
The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards. Statement 1063
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available. Statement 1024
Warning This unit might have more than one power supply connection. All connections must be removed to de-energize
the unit. Statement 1028
Warning Only trained and qualified personnel should be allowed to install, replace, or service thisequipment. Statement
1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
For connections outside the building where the equipment is installed, the following ports must be connected
through an approved network termination unit with integral circuit protection. 10/100/1000 Ethernet Statement
1044
Switch Installation
2
Switch Installation