Memory Parity Mode
Determines whether a parity check is carried out in the case of DRAM modules.
If the system BIOS detects that at least one DRAM module does not have a parity bit, the parity
check is generally disabled.
No parity check is performed. Use this setting for all non-ECC memory modules.
The parity check is set in parity mode. A bit corruption is recognized and an error
message is issued. This setting is not recommended.
A bit corruption is corrected (no error message). An error message is issued for two
or more bit corruption's. Use this setting for all ECC memory modules.
PnP / PCI Options
Calls the submenu in which you can make the settings for Plug&Play and the PCI bus.
*PnP / PCI Options
*PCI IRQ Setting ....................... [Auto]
*PCI Slot 1 ......................... [--] [--] [--] [--]
*PCI Slot 2 ......................... [--] [--] [--] [--]
*PCI IRQ Sharing ....................... [Yes]
*VGA Palette Snoop ..................... [Disabled]
*Graphics Aperture Size ................ [64MB]
*Plug and Play OS ...................... [No]
*Reset Resource Assignments ............ No
↑↓ = Move Highlight Bar
Esc = Exit
Example for the PnP / PCI Options submenu
PCI IRQ Setting
defines the setting of the PCI interrupts.
Select Auto, if you use PCI boards supporting plug&play. Otherwise select Manual.
A26361-K522-Z122-3-7419
INTA INTB INTC INTD
F1 = Help
→ ← = Change Setting,
BIOS Setup
Page 1/1
English - 29