Back-Up Lamp - Buick 1999 Regal Owner's Manual

Back-Up Lamp

-
The back up lamps are located in the trunk lid applique.
(Refer to the trunk lid applique removal procedure earlier
in this section for graphic and further instructions.)
1. Remove the trunk lid applique.
2. Twist and pull the back
trunk lid applique.
3. Twist and pull the bulb from the back
lamp socket.
To install the new bulb:
1. Twist and push the bulb into the back
lamp socket.
2. Twist and push the back
trunk lid applique.
3. Reinstall the trunk lid applique.
-
up lamp socket from the
-
up
-
up
-
up lamp socket into the
Dome Lamp (If Equipped)
1. Grasp the front center and rear center positions of the
dome lamp housing and squeeze together until the
housing releases from the base plate. A screwdriver
may be necessary to pry the assembly loose.
2. Lift the plastic locking tab on the electrical
connector and pull the connector from the dome
lamp assembly.
3. Grasp the bulb housing located in the center of the
assembly and pull straight up.
4. Pull the bulb out of the socket.
5. Push in a new bulb.
6. Replace the socket into the dome lamp assembly.
7. Reconnect the dome lamp assembly to the wiring
harness, making sure the connector tab snaps
into place.
8. Reposition the dome lamp assembly to the roof, and
gently push the assembly into the base plate.
yellowblue
6-43