Replacing Battery - BMW 2010 528 Owner's Manual

Replacing battery

If the battery of the remote control is dead, a
message will appear in the Control Display.
1. Remove integrated key from remote con-
trol, refer to page 26.
2. Remove cover.
3. Lay in new battery with positive side facing
upward.
4. Press cover closed.
Return used battery to a recycling collec-
tion point or to your BMW
Windows
To prevent injuries, exercise care when
closing the windows and keep them in
your field of vision until they are shut.
Always take along the remote control when you
leave the vehicle, otherwise children could, for
example, operate the windows and injure them-
selves.<
Opening, closing
> Press switch to resistance point:
The window continues to open as long as
you keep the switch pressed.
38
Online Edition for Part no. 01 41 2 602 678 - © 08/09 BMW AG Online Edition for Part no. 01 41 2 602 678 - © 08/09 BMW AG
> Press switch beyond resistance point:
The window opens automatically. Pressing
the switch again stops the opening move-
ment.
You can close the windows in the same manner
by pulling the switch.
Separate switches for the rear windows are
located in the rear.
For information on using Convenient opening
and closing at the door lock or with the remote
control, refer to page
For information on comfort closing with Com-
fort Access, refer to page 37.
After switching off ignition
You can still operate the windows with the
remote control removed or the ignition
switched off for approx. 1 minute, as long as
neither of the front doors has been opened.
Pinch protection system
center.<
If the closing force exceeds a specific value as a
window closes, the closing action is interrupted
and the window reopens slightly.
closing it, as the safety system might fail to
detect certain kinds of obstructions, such as
thin objects, and the window would continue
closing.
Do not install any accessories in the range of
movement of the windows, otherwise the pinch
protection system will be
Closing without pinch protection
system
In case of danger from outside or if, for example,
ice on the window prevents normal closing, pro-
ceed as follows:
1. Pull the switch beyond the resistance point
and hold. The pinch protection system is
limited and the window opens slightly if the
closing force exceeds a certain value.
2. Pull the switch beyond the resistance point
and hold again within approx. 4 seconds.
28 or 30.
Despite the pinch protection system,
inspect the window's travel path prior to
impaired.<