Canon PD-82K Service Manual page 12

CHAPTER 1
III. INSTALLATION
A. Notes
Use the following power supplies;
• Line voltage (AC): -10%, +6% rated voltage
• Power frequency: 50/60Hz ± 2Hz
B. Unpacking and Installation
Condensation will form on the metal surfaces when brought into a warm room from the cold.
Therefore, when moving the unit into a warm environment, leave it packed in its box for at least
an hour to acclimatize to room temperature.
1. Opening the paper deck packaging
1) Undo the paper deck packaging, and remove the box.
2) Take out the accessories. Confirm that the option interface cable and manual are included.
3) Remove the top pads (left/right) and remove the paper deck from the box.
4) Take the plastic bag off from around the deck and peel off the tape holding the various parts.
Check that none of the covers were scratched or deformed during shipment.
5) Open the feed unit and remove the spacer.
6) Pull out the cassettes and remove the spacer.
2. Connecting to the printer
1) Carry to the installation location and lock the casters.
2) Rotate the adjusters to install on the floor.
3) Open the feed unit.
4) Line up the printer and paper deck in the same direction, and have 4 people lift the printer.
Lower the printer onto the paper deck while aligning the 3 positioning pins on the paper
deck.
5) Close the feed unit.
6) Connect the 15-pin-connector of the interface cable with the paper deck, and the 14-pin-
connector with the printer.
7) Plug the power cord into the paper deck and the outlet.
Note: When connecting the interface cable with the printer and the paper deck, note that the
connectors at the ends of the interface cable contain different number of pin, 15 pins
and 14 pins.
15-pins connector
1 - 4
14-pins connector
Figure 1-3-1