BMW 2006 X5 Owner's Manual page 89

Computer in MID
*
After three incorrect code entries, or
three attempts to start the engine with-
out a code entry, the alarm will sound
for 30 seconds on vehicles fitted with
an alarm system.
Deactivating the alarm in an emer-
gency:
If you have forgotten the code, proceed
as follows:
1. Disconnect the battery, wait approx.
2 minutes, then reconnect it. Note
that on vehicles with an alarm sys-
tem, the alarm will sound
2. Set the ignition key to position 1: the
time display will count down for the
next ten minutes
3. After ten minutes, start the engine.
If the code becomes available
again in the meantime, it can be
entered during the waiting period after
pressing the CODE button.<
Remote control
The computer button on the turn signal
lever can be used to select the items of
computer information to be displayed.
To do this, press:
> the button on the lever until PROG
shows on the display
> the MID buttons in the order in which
you wish the information to be dis-
played.
Each time an entry is stored, the pro-
gram number appears on the display.
To terminate the selection procedure:
Press the right side of the button.
To have all the available information
displayed, press
> the button on the lever until PROG
shows on the display
> the SET button.
To obtain individual items of informa-
tion, briefly press the button as often as
necessary.
Online Edition for Part No. 01 41 0 159 867 - © 07/05 BMW AG
89n