Acura 2008 TL Owner's Manual page 301

Main Menu
Lights
2. Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
3. Remove the bulb by turning it one-
quarter turn counterclockwise.
298
Table Of Contents
4. Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
5. Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
6. Turn on the lights to test the new
bulb.
7. (Driver's side)
Install the upper part of the air
intake duct.
8. (Driver's side)
Install the engine compartment
corner cover, and secure it with
two fastener pins.
9. Install the engine compartment
side cover.
2008 TL
Replacing the Front Turn Signal/
Parking Light Bulb
1. Start the engine. If you are
replacing a driver's side bulb, turn
the steering wheel all the way to
the right. If you are replacing a
passenger's side bulb, turn the
steering wheel to the left. Turn off
the engine.