Remote Vehicle Start - GMC Buick Encore 2022 Owner's Manual

2. Separate the two halves of the
transmitter using a flat tool inserted into
the area near the key slot.
3. Remove the battery by pushing on the
battery and sliding it toward the bottom
of the transmitter.
4. Insert the new battery, positive side
facing the back cover. Push the battery
down until it is held in place. Replace
with a CR2032 or equivalent battery.
5. Snap the battery cover back on to the
transmitter.
6. Reinsert the key.

Remote Vehicle Start

The vehicle may have this feature that
allows you to start the engine from outside
the vehicle.
: This button will be on the RKE
transmitter if the vehicle has remote start.
The climate control system will use the
previous settings during a remote start.
Laws in some local communities may restrict
the use of remote starters. For example,
some laws require a person using remote
start to have the vehicle in view. Check local
regulations for any requirements.
Do not use remote start if the vehicle is low
on fuel as it may run out of fuel.
Other conditions can affect the performance
of the transmitter. See Remote Keyless Entry
(RKE) System 0 7.
Starting the Vehicle
To start the engine using the remote start
feature:
1. Press and release .
2. Immediately after completing Step 1,
press and hold for at least
four seconds or until the turn signal
Keys, Doors, and Windows
lamps flash. The turn signal lamps
flashing confirms the request to remote
start the vehicle has been received.
When the engine starts, the parking lamps
will turn on and remain on as long as the
engine is running. The doors will be locked
and the climate control system may
come on.
The engine will continue to run for
15 minutes. After 30 seconds, repeat the
steps if a 15-minute extension is desired.
Remote start can be extended only once.
Press ENGINE START/STOP and the brake
with the RKE Transmitter in the vehicle to
drive.
Extending Engine Run Time
The engine run time can also be extended
by another 15 minutes, if during the first
15 minutes Steps 1 and 2 are repeated while
the engine is still running. An extension can
be requested 30 seconds after starting. This
provides a total of 30 minutes.
The remote start can only be extended once.
When the remote start is extended, the
second 15-minute period is added on to the
first 15 minutes for a total of 30 minutes.
13