Thermador DC30MTW Installation Manual page 7

Make the pilot holes depending on your duct cover
6.
width.
Gently dettach the mounting template and turn it 180°.
7.
Locate the template against the centerline to make the
other pilot holes. Install the wall anchors depending on
the wall material (wood or plywood).
Mount the duct cover bracket on the top of the ceiling
8.
using four 5 x 45 mm screws (wood) or four 5.4 x
75 mm (plywood). Ensure that the bracket is leveled.
Insert the complete duct cover at an angle and swivel
9.
toward the wall.
Carefully pull the top part of the extension upwards.
10.
Screw the left and right sides of the extension to the
mounting bracket with the supplied installation screws.
From inside of hood, screw the supplied 4.2 x 8 mm
11.
sheet metal screws through the holes on each side
and along the front into bottom of the extension.
7