Messages - Sony MZ-NHF800 Operating Instructions Manual

Messages

If the following messages flash in the display window on the recorder, check the chart
below.
Message Meaning/Remedy
AVLS NO • AVLS is set to "AVLS On" and so the volume cannot rise higher.
, Set AVLS to "AVLS Off" (page 70).
VOLUME
OPERATION
BLANKDISC • A disc with no recording on it is inserted.
BUSY WAIT • The recorder is accessing disc information.
A MOMENT • You tried to operate the recorder while it was accessing the recorded data.
, Wait until the message goes out (in rare cases, it may take a few
CANNOT • You selected, "
EDIT recording.
• You tried to erase the track mark at the beginning of the first track or group.
• You tried to erase a track mark to combine tracks the recorder cannot
combine (a track recorded in stereo and in mono, for example).
• You tried to overwrite a track marks.
• You tried to change a title that includes characters the recorder cannot edit.
, Editing titles cannot be done if the title includes characters that cannot
• You tried to press X or T MARK during synchro-recording.
CANNOT
OPERATE
CANNOT • There is no audio data that can be played on the recorder.
RECORD OR • The audio data or disc management file has been damaged.
, Erase the whole disc (page 65) or perform the Format function
PLAY
CANNOT • You tried to make the Time Mark setting during synchro-recording.
SET • You selected "RECVolume" while the recorder is not in recording-pause.
, Set "RECVolume" while the recorder is in recording-pause.
• You tried to make the following settings while recording.
— Disc Memory
— Play mode
— Recording mode
— Recording level
— Selection of "
DATA SAVE • The recorder is writing information to the disc, such as the recorded data or
editing information.
, Wait until the message disappears from the display.
DC IN TOO • Voltage of the power supply is too high (The supplied AC power adaptor or
HIGH the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car battery
DISC FULL • Recording may not be done if the remaining recordable time on the disc is
48 seconds or less.
, Replace the disc.
minutes).
: Set", "
be input on the recorder.
(page 69).
:REC" in menu
cord.
: Release", "Move", or "Erase" while
93