Compaq Presario 7400 Series Maintenance And Service Manual page 145

Compaq.com - Compaq Presario Maintenance and Service Guide - 7400 Series
http://www.compaq.com/athome/support/msgs/7400/config.html (2 of 4) [1/8/2002 3:52:58 PM]
1 Ensure proper ventilation. The computer should have a 3-inch (7.6 cm)
clearance at the back of the system unit.
2 Turn off the computer and peripheral devices.
CAUTION: Always ensure that the power is off before
disconnecting or reconnecting the mouse, keyboard, or any other
peripheral devices. Disconnecting or connecting the keyboard or
mouse while the unit power is on can damage the system board.
3
Disconnect any peripheral devices other than the monitor and keyboard.
Do not disconnect the printer if you want to test it or use it to log error
messages.
4 Install loop-back and terminating plugs for complete testing.
Setup
The Setup utility gives a snapshot of the computer's hardware configuration, aids in
troubleshooting, and sets custom features. Setup recognizes a new internal component or an
external device and automatically updates the configuration screens. Use the Setup utility to:
Modify settings for audio, storage, power management, communications, and
input devices
Get an overall picture of the computer's hardware configuration
Verify configuration parameters in determining problems
Set time and date
Running Setup
To access the Setup utility, turn on the computer and press the F10 key when the Compaq
logo appears. The following menu will appear:
The actual menu displayed on your computer may
NOTE:
vary slightly, depending on your configuration.