Getting started Battery installation & charging Install the battery as shown below. After installing the battery, you can make and receive short calls, but replace the handset in the telephone base or charger when not in use. For optimal performance, charge the handset battery for at least 6 hours before use.
Getting started Installation preparation If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack (see the following page). The filter will prevent noise and caller ID problems caused by DSL interference.
Getting started Telephone base & charger installation Install the telephone base as shown below. Make sure that the electrical outlet is not controlled by a wall switch. If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack.
Getting started Telephone base & charger installation Charger installation IMPORTANT INFORMATION Use only the power adapter(s) supplied with this product. To order a replacement power adapter, visit our website at 1 (800) 222-3111 The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the- table or cabinet outlet.
Getting started Quick reference guide - handset CHARGE indicator On when the handset is charging in the telephone base or charger. DIR / Press to display directory entries. Press to scroll up while in menus. While entering names or numbers, press to move the cursor to the right.
Page 7
Getting started Quick reference guide - telephone base IN USE indicator • On when the handset is in use, when the answering system is answering an incoming call or when you are registering a handset. • Flashes when another telephone is in use on the same line or when you are deregistering handset(s) from the...