Panasonic KMF0209634C2 Service Manual page 96

3.5.7.1 JOURNAL 2
TOP PREVIOUS NEXT
Refer to JOURNAL 2 in
Journal 2 displays the additional detailed information about the last 35 communications.
Descriptions:
(1) RCV. MODE
Indicates which receive mode the unit was in when the unit received a fax message.
This information is also displayed when the unit transmitted a fax message.
(2) SPEED
Indicates the speed of the communication. If multiple pages are transmitted or received, it indicates
the last page's communication speed. If there is a communication error, "?" is displayed.
(3) RESOLUTION
Indicates the resolution of the communication. If multiple pages are transmitted or received, it
indicates the last page's resolution. If there is a communication error, "?" is displayed.
(4) RCV-TRIG. (CNT.)
Indicates the trigger that causes the unit to switch to the fax receive mode. The available options are
listed in JOURNAL 2 in
times the trigger has been used. (For example, "0003" means three times.)
No. Display
1 FAX MODE Means the unit received a fax message in the FAX mode.
2 MAN RCV Means the unit received a fax message by manual operation.
3 FRN RCV Means the unit received a fax message by friendly signal detection.
4 VOX Means the unit detected silence or no voice.
5 RMT DTMF Means the unit detected DTMF (Remote Fax activation code) entered remotely.
6 PAL DTMF Means the unit detected DTMF (Remote Fax activation code) entered by a parallel connected telephone.
7 TURN-ON Means the unit started to receive after 10 rings. (Remote Turn On: Service Code #573)
8 TIME OUT Means the unit started to receive after Ring Time Out in the EXT-TAM or TEL/FAX mode.
9 IDENT Means the unit detected Ring Detection.
10 CNG OGM Means the unit detected the CNG while it was sending the Dummy Ring Back Tone in the TEL/FAX mode.
OR
Means the unit detected the CNG while it was sending the OGM in the ANS/FAX mode.
11 CNG ICM Means the unit detected the CNG while it was recording the ICM in the ANS/FAX mode.
(5) ERROR→MEMORY
Indicates the reason why the unit received a fax message in memory.
If you look at No.11 in the JOURNAL 2 in
file://C:\Documents%20and%20Settings\Admin\Plocha\SCHÉMATA\VIDEA\PAN...
PRINTOUT EXAMPLE
PRINTOUT EXAMPLE
PRINTOUT EXAMPLE
http://servis-manual.com/
().
(). The values in parenthesesindicate how many
Function
(), it shows the fax message was
Stránka č. 1 z 2
27. 10. 2004