Clutch Lever - Yamaha Y16ZR 2021 Owner's Manual

Dimmer/Pass switch "
Set this switch to " " for the high
beam and to " " for the low beam.
To ash the high beam, push the
switch down towards "PASS" while the
headlights are on low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Light switch " /OFF"
Set the light switch to "
the headlight, taillight and meter light-
ing. Set the switch to "OFF" to turn off
all the lights.
EAU54203
/ /PASS" Engine stop switch "
Set this switch to "
starting the engine. Set this switch
to " " (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
EAU12461
" Start switch "
Push this switch to crank the engine
with the starter. See page 7-2 for start-
". When ing instructions prior to starting the en-
gine.
EAU12501
EAUV0940
" to turn on
Instrument and control functions
EAU12664

Clutch lever

/ "
" (run) before
EAU12713
"
1. Clutch lever
The clutch lever is located on the left
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the start-
ing circuit cut-off system. (See page
5-16.)
5-9
EAU31642
1
5