Advertisement
surface while providing a bright beam to
mark your settings by.
MAINTENANCE AND
SERVICING
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FROM ACCIDENTAL
OPERATION:
Turn the OFF the Laser Level
before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Installing and Removing Batteries
1.
Remove the Battery Cover (13) located
under the On/Off Button (9). See Figure
7, below.
SKU 90980
TO PREVENT
SERIOUS INJURY
Battery Cover
(13)
Figure 7
For technical questions, please call 1-800-444-3353.
2.
The Laser Level uses two (2) "AAA"
batteries. Remove the old batteries and
insert two new batteries. See Figure 8,
below.
3.
WARNING! Verify batteries are inserted
according to indicated polarity (so that
positive and negative ends match the
diagram on the end of the Laser Level).
4.
Replace the Battery Cover (13).To
prevent accidents, turn off the tool and
disconnect its power supply after use.
Cleaning, Maintenance, and
Lubrication
1.
BEFORE EACH USE, inspect the
general condition Laser Level. Check for
loose hardware, misalignment or binding
of moving parts, cracked or broken parts,
and any other condition that may affect
its safe operation.
2.
AFTER USE, wipe external surfaces of
the tool with clean cloth.
3.
Store the Laser Level indoors and out of
children's reach.
"AAA"
Batteries
Figure 8
Page 6
Advertisement
