Nokia RH-41 Series Assembly page 5

CCS Technical Documentation
Place the engine module on top of the
LCD module.
Assemble the D-cover assembly.
Step 1. Place the assembled D-cover on top of the
C-cover.
Step 2. Press the D-cover to snap the side locks.
Assemble the keymat onto the front cover.
Step 1. Place the keypad onto the front
cover before the cover is assembled
to the basic transceiver.
Step 2. Press the keypad into its place.
Issue 2 09/2003
11.
12.
Note: The use of gloves is mandatory in order to
14.
15.
16.
Nokia Corporation
Note: The use of gloves is mandatory in
order to prevent fingerprints from
appearing on the engine layout. Use
ionized air or a vacuum, before
assembling the D-cover, to remove
dust and other foreign particles
from the PWB assy.
Place the system connector on top of the
engine module.
prevent fingerprints from appearing on
the engine layout and system connector
pads (charging pads). Make sure that the
system connector springs stay intact. The
springs may be damaged, if touched.
13.
Assemble the screws.
Step 1. Fasten the 6 screws. The assembly
order is shown in the disassembly
section. The torque is 20 - 21 Ncm
350/RPM.
Assemble the front cover onto the basic
transceiver.
Step 1. First push the basic transceiver to the
front cover's IR window.
Step 2. Press the bottom part onto the front
part, so that it snaps onto the front
cover.
Confidential
RH-41
Assembly
Page 5