Nokia RH-41 Series Assembly page 4

RH-41
Assembly
Note: If the battery connector or the buzzer assembly is in
place, make sure that the battery connector springs
and the buzzer springs stay intact. The springs may be
damaged, if touched.
Step 10. Place the buzzer assembly into its place.
Use tweezers.
The buzzer is assembled into the D-cover with
interference fixing.
Note: Make sure that the speaker springs stay intact. They may be damaged, if touched.
Place the LCD module onto the C-cover.
Page 4
Step 9. Place the vibra assembly into its slot. Use
6.
The vibra is assembled into the D-cover with
interference fixing.
8.
9.
10.
Nokia Corporation
CCS Technical Documentation
tweezers.
7.
Step 11. Place the release spring into the
D-cover slot.
The release spring is attached onto the
D-cover with screws that are used for
attaching the C- and D-covers. No heat
staking is needed.
Assemble the C-cover.
Step 1. Check the condition of the screw holes.
If they are worn out, change the cover.
Step 2. Place the C-cover into a jig. Make sure
that the speaker with the speaker
gasket is in place.
Note: the use of gloves or a vacuum picker
is required, in order to prevent
fingerprints from appearing on the
LCD. Make sure that the elastomer
connector and domes stay intact
during assembly. Use compressed air
or a vacuum before assembling
the D-cover, in order to prevent
dust from getting onto the engine
layout.
Confidential Issue 2 09/2003