Advertisement
Electrical Specifications
Model
Item
Power input
Output power
Maximum output current
Ripple & noise
Efficiency
Overcurrent/short circuit
protection
Overvoltage/
overtemperature
protection
Grounding
Operation environment
Storage environment
UL
Agency
approvals
CE
Weight (g)
Installation and Wiring
Mounting Arrangements and Wiring
DIN Rail Installation:
The DVPPS can be secured to a cabinet by using the DIN rail
that is 35mm high with a depth of 7.5mm. When mounting the
DVPPS on the DIN rail, be sure to use the end bracket to stop
any side-to-side motion of the DVPPS, thus to reduce the
chance of the wires being pulled loose. On the bottom of the
DVPPS is a small retaining clip. To secure the DVPPS to the
DIN rail, place it onto the rail and gently push up on the clip. To
remove it, pull down on the retaining clip and gently pull the
DVPPS away from the DIN rail. Please see the figure on the
right:
Direct mounting: Tighten M4 screws into direct mount hole.
DVPPS01
100 ~ 240VAC (-15% ~ +10%), 50/60Hz
24VDC (±3%)
1 A
Under 100mV
Typical at
p-p
full load
78% ~ 87% Typical at full load
Auto Recovery
The diameter of grounding wire cannot be smaller than the wire diameter of terminals L and
N (All PLC units should be grounded directly to the ground pole).
0°C~55°C (temperature), 50~95% (humidity), Pollution
degree 2
-25°C~70°C (temperature), 5~95% (humidity)
UL508 Listed (Industrial Control Equipment)
European Community EMC
Directive 89/336/EEC and
Low Voltage Directive
73/23/EEC
158
DVPPS02
2 A
Under 240mV
Typical at full load
p-p
--
EMC Directive 2004/108/EC and Low Voltage Directive
2006/95/EC
250
DVPPS05
5 A
Above 88% Typical at full load
Overvoltage protection: The
power supply is cut off for 5
seconds. DVPPS05 operates
normally after power is
supplied.
Overtemperature protection:
The power supply is cut off for
5 seconds, and the
temperature inside DVPPS05
falls to the temperature below
o
85
C. DVPPS05 operates
normally after power is
supplied.
-20°C~55°C (temperature),
50~95% (humidity),
Pollution degree 2
488
For heat dissipation. Make
sure to provide a minimum
clearance of 50mm between
the unit and all sides of the
cabinet. (as shown below)
Advertisement
