1
1. Do not touch the glass part of the bulb.
Bulb type:
Halogen bulb
6.
Install the bulb holder cover, and then
connect the headlight coupler.
7.
Close the shroud.
ESU12251
Adjusting the headlight beams
1.
Open the shroud.
2.
Remove the locking pin.
1. Locking pin
3.
Turn the headlight beam adjusting
screws in or out to adjust the headlight
beams. The headlight beams move as
follows depending on the turning direc-
tion of the headlight beam adjusting
screws.
Direction (a): Down and to the left
Direction (b): Up and to the right
Direction (c): Down and to the right
Direction (d): Up and to the left
Periodic maintenance and adjustment
1. Headlight beam adjusting screw
4.
Install the locking pin, and then close the
shroud.
ESU12291
Fittings and fasteners
Check the tightness of the fittings and fasten-
ers.
Tighten in proper sequence and torque if
necessary.
ESU14021
Battery
The battery is located under the air filter case.
(See page 72.)
This model is equipped with a VRLA (Valve
Regulated Lead Acid) battery. There is no
need to check the electrolyte or to add dis-
tilled water. However, the battery lead con-
nections need to be checked and, if
necessary, tightened.
EWS00541
WARNING
Battery electrolyte is poisonous and dan-
gerous. It contains sulfuric acid and can
cause severe burns. Avoid contact with
skin, eyes, or clothing.
ANTIDOTE:
EXTERNAL: Flush with water.
INTERNAL: Drink large quantities of wa-
ter or milk. Follow with milk of magne-
sia, beaten egg, or vegetable oil. Call
physician immediately.
EYES: Flush with water for 15 minutes
and get prompt medical attention.
71