Loose Parts - RIDGID AC9960 Operator's Manual

LOOSE PARTS

The following items are included with your miter saw stand
 Wheels ......................................................................... 2
 Axles ........................................................................... 2
 Wheel Assembly Hardware:
Nut (M8) ....................................................................... 4
Large Flat Washer (M8) ................................................ 2
Flat Washer (M8) .......................................................... 4
 Carry Handle ................................................................ 1
 Carry Handle Assembly Hardware:
Bolt (M8 x 15mm) ........................................................ 2
Flat Washer (M8) .......................................................... 2
Lock Washer (M8) ........................................................ 2
ASSEMBLY
UNPACKING
This product requires some assembly.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the loose parts list
are included.
WARNING:
Do not use this product if any parts on the loose
parts list are already assembled to your product
when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
 Saw Mounting Brackets .............................................. 2
 Saw Mounting Bracket Hardware
Bolt (M8 x 35 mm) ....................................................... 4
Flat Washer (M8) .......................................................... 4
Lock Washer (M8) ........................................................ 4
 Material Supports ........................................................ 2
 Height Adjustment Knobs ............................................ 2
 Operator's Manual
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in acci-
dental starting and possible serious personal injury.
ATTACHING THE HANDLE
See Figure 3.
CAUTION:
Be careful to avoid pinching your fingers or hands
when installing the handle onto the frame.
Attach the handle on the end of the frame opposite the wheels.
 W ith the stand out of the box and packaging removed,
lay the stand's top surface down on the floor with the
folded legs facing up.
 Hold the handle on the outside of the frame as shown
 Align the holes in the handle with the holes in the frame.
CARRY
HANDLE
LEG
5 - English
LOCK
FLAT
WASHER
WASHER
BOLT
Fig. 3