Page 2
Operating Instructions 207.5184.81 Thank you for choosing our appliance. We are sure it will provide you with trouble-free use. In the following, we would like to familiarise you with some symbols, which we bring to your attention to ensure the safe and efficient operation of the appliance: source of danger, in event of improper operation suggested useful tips to read information concerning environmental protection This...
Page 3
1. Unpacking 2. View of the appliance 3. Cleaning .4. Positioning the appliance .4.1. Installation instruction .5. Using the appliance .5.1. Temperature regulation 6. Ice cubes 7. Useful suggestions 8. Defrosting, cleaning and maintenance 9. Changing the lightbulb 10. Reversing the door hang 11.
7. Ventilation grills, if used, must have 3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these parts, as well as the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth.
Page 7
Figure 2. Figure 3. The refrigerator can be fixed to the bottom of the furniture through its fixing feet using screws of an appropiate length. (Fig. 4)
Figure 4. During installation, please ensure the mains plug is accessible at all times. 5. Using the appliance To start the refrigerator connect the plug to the socket outlet and switch on the socket. The cooling fins should show signs of cooling after about 3 hours. The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage compartment.
leave some space between the products in the cabinet to ensure efficient and even cooling. If the shelves are packed too tightly there may be unacceptable temperature variations. 8. Defrosting, cleaning and maintenance Frost will gradually form on the cooling surfaces and it must not be allowed to become too thick since it restrict the cooling.
Figure 7. 11. Replacing the decorative door panel, (Fig. 8-10) Remove the two screws (1) from the upper hinge of the door. Pull the door together with the hinge away from the housing and up off the lower hinge bolt (2-3). Remove screws (4) and pull off the frame edge (5).
Figure 9. Figure10. 12. Customer service Before you call a service engineer, carry out the following simple tests: Is there a power failure? Check the fuses. Is the plug firmly connected to the socket and is the socket switched on? Check the socket by plugging in another appliance, e.g.
This refrigerator is equipped with overheating protection. An authorised service technician can check whether this has been triggered or not. In the event of a fault developing, contact your nearest Service Centre-see local telephone directory. 13. Putting into operation Technical data: Model RH 131 RH 141...
The wire coloured brown must be connected to the terminal marked .L. or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. 14. Environmental protection information The appliance does not contain any CFCs/HCFCs.
Page 14
Printed by Xerox Hungary Ltd. 2005. 06. 14.