Advertisement
Available languages
Available languages
::
.com
bathroomsource
PREPARE THE FAN / LIGHT
1. Remove the screw holding the blower assembly in place. Lift
assembly from housing.
2. Slide adjustable mounting brackets into bracket channels on
housing. NOTE: Housing may be mounted directly to joist
using keyholes provided.
INSTALL THE FAN / LIGHT
1. Position housing between joists and extend mounting brack-
ets. Position brackets such that bottom edge of housing will be
flush with finished ceiling. Mark the top of keyhole on all four
mounting brackets.
Broan at
Call 1-800-667-8721 anywhere in the US and Canada -
::bathroomsource.com
INSTALL THE FAN / LIGHT
(CONT'D)
2. Remove housing temporarily, and pound nails partially into
joists at all four marked locations.
3. Hang housing from nails. Use measuring guides on corners
of housing to check if unit will be flush with finished ceiling.
Pound nails tight. For wide joist centers: A #8 x 3/8 self-tapping
screw can be used to join extended brackets together and
create a rigid mount. To ensure a noise-free mount, crimp the
bracket channels tightly around mounting brackets.
4. Snap the damper/duct connector onto housing. Make sure that
tabs on the duct connector lock in housing slots and that gravity
closes damper.
5. Install 4" round duct and extend duct to outside through a roof
or wall cap. Check damper to make sure that it opens freely.
Tape all duct connections to make them secure and air tight.
2
kitchen::
is a division of
U
N
www.bathroomsource.com
1½" FOR
½" DRYWALL
accessories
L
I
M
I
T
E
D
Advertisement
