Chapter 4: Setting Up And Connecting The Wireless-Nusb Network Adapter; Starting The Setup; Figure 4-1: Setup Wizard's Welcome Screen; Figure 4-2: Setup Wizard's License Agreement - Cisco LINKSYS WUSB300N Manual

Wireless-N USB Network Adapter
Chapter 4: Setting up and Connecting the Wireless-N
USB Network Adapter

Starting the Setup

The Wireless-N USB Network Adapter Setup Wizard will guide you through the installation procedure. The Setup
Wizard will install the driver and Wireless Network Monitor, as well as connect and configure the Adapter.
IMPORTANT: Do not connect the Adapter until you are instructed to
do so or the setup will not work.
Insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup Wizard should run automatically, and the
Welcome screen should appear. If it does not, click the Start button and choose Run. In the field that appears,
enter D:\setup.exe (if "D" is the letter of your CD-ROM drive).
If asked, select your preferred language. Then click Next/Install.
On the Welcome screen, you have the following choices:
Click Here to Start- Click the Click Here to Start button to begin the software installation process.
User Guide - Click the User Guide button to open the PDF file of this User Guide.
Diagnostic - Click the Diagnostic button to run a diagnostic check on your installed Network Adapter's Wireless
Network Monitor and driver.
Exit - Click the Exit button to exit the Setup Wizard.
1. To install the Adapter, click the Click Here to Start button on the Welcome screen.
2. After reading the License Agreement, click the Next button if you agree and want to continue the installation,
or click the Cancel button to end the installation.
3. Windows will begin copying the files onto your PC.
Chapter 4: Setting up and Connecting the Wireless-N USB Network Adapter
Starting the Setup

Figure 4-1: Setup Wizard's Welcome Screen

Figure 4-2: Setup Wizard's License Agreement

6