Specifications - Sony STR-DH130 Operating Instructions Manual

Remote control
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver.
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• Make sure you select the correct input on
the remote control.
Error messages
If there is a malfunction, a message appears on
the display panel. You can check the condition
of the system by the message. If any problem
persists, consult your nearest Sony dealer.
PROTECT
Irregular current is output to the speakers, or
the receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
Clearing the memory
Reference section
To clear
All memorized settings
GB
32

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(USA model only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
USA, Canada and Europe models
Minimum RMS Output Power (8 ohms, 20 Hz –
20 kHz, THD 0.09%)
Stereo Mode Output Power (8 ohms, 1 kHz,
THD 1%)
1)
Area
USA, Canada
Europe
Frequency response
Input
See
page 18
Inputs
Outputs
90 W + 90 W
100 W + 100 W
Measured under the following conditions:
Power requirements
120 V AC, 60 Hz
230 V AC, 50 Hz
Analog 10 Hz – 70 kHz
+0.5/–2 dB (with BASS =
0 dB, TREBLE = 0 dB)
Analog (PORTABLE IN)
Sensitivity: 1 V/
50 kilohms
S/N
Analog (Except PORTABLE IN)
Sensitivity: 500 mV/
50 kilohms
S/N
Analog (AUDIO OUT)
Voltage: 500 mV/
10 kilohms
1)
2) 3)
: 96 dB (A, 500 mV
2) 3)
: 96 dB (A, 500 mV
)
)