U-Line ADA Series Use And Care Manual page 10

Ice Maker Maintenance
Ice Cube Thickness Adjustment
Interval - As Required
On ice maker equipped models, the cube size may be
adjusted by changing the amount of water injected into
the ice maker assembly as follows:
Figure 5
1. Remove the ice maker assembly cover (Figure 6).
Figure 6
2. Locate the adjusting screw on the ice maker assembly
control box. The adjusting screw is just below the minus
(-) and plus (+) signs on the control box (Figure 7).
NOTE: Make adjustments in small increments. Too
large of an adjustment could cause the unit to
malfunction.
CAUTION
Too large of an adjustment to the screw can cause
the water to overflow the ice maker and can cause
property damage.
8
ULIN_0275_A
ULIN_0056_A
ADA15IM
3. Turn the adjusting screw toward the minus (-) sign
(clockwise) for smaller cubes or toward the plus (+) sign
(counterclockwise) for larger cubes.
4. Install the ice maker assembly cover.
IMPORTANT IMPORTANT
Use only genuine U-Line replacement parts. U-Line
ice maker parts are not the same as standard FSP
Whirlpool parts. Using non U-Line parts can reduce
ice rate, cause water to overflow from ice maker
mold, damage the unit, and may void the warranty.
Leveling
Place
level
here
Figure 7
1. Use a level to check the levelness of the unit from front
to back and from side to side. Level should be placed
along top edge and side edge as shown (Figure 8).
Figure 8
2. If the unit is not level, adjust the feet on the corners of
the unit as necessary (Figure 9).
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level.
ADA SERIES
ULIN_0043_A
1
ULIN_0044_A