Table of Contents
Advertisement
Advertisement
Table of Contents
Troubleshooting
Summary of Contents for CAMAG TLC
- Page 1 INSTRUCTION MANUAL TLC/HPTLC SPRAYER...
-
Page 2: Table Of Contents
Content: Introduction ............................ 3 Basic overview........................... 3 Precautions ..........................3 Parts supplied/Accessories/Consumables ................... 4 Unpacking/Installation ........................5 Installation of pump unit ......................5 Connect the spray unit ......................6 Hints ............................6 Getting started ..........................6 Maintenance/Troubleshooting ..................... 6 Maintenance ..........................6 Decontamination ........................ -
Page 3: Introduction
TLC Sprayer 1 Introduction 1.1 Basic overview The CAMAG TLC Sprayer is used for spraying reagents on TLC plates for the derivatization of substances. Air is used as propellant. 1.2 Precautions • Please read this operating manual before starting the installation! This manual... -
Page 4: Parts Supplied/Accessories/Consumables
TLC Sprayer CAMAG only. The warranty is voided if parts from other sources are used. Check the service manual before you start service to reduce product-specific risks • If the instrument is found to be defective, it must be switched off and steps must be taken to ensure that it cannot be switched on by mistake •... -
Page 5: Unpacking/Installation
TLC Sprayer The following consumable parts are available for the CAMAG TLC Sprayer: Cat. No. Quantity Description 022.6535 Package of 6 5 spray head type A, 1 spray head type B 022.6538 Package of 6 Spray head type B 022.6534 Compressed air connector 022.6536... -
Page 6: Connect The Spray Unit
If the instrument is not used for a longer time, disconnect the mains connection. 3 Getting started Remove the charged and prepared TLC Sprayer unit from the charger unit and start spraying by pressing the control switch (9). CAMAG recommends to start spraying at a distance of 20cm from the plate. Move the sprayer in a steady motion over the plate until the surface is sufficiently wet (to get best results, stop before the plate is totally wet). -
Page 7: Decontamination
Inductive charge: 45 - 50 mA / 14 - 16 hours Avoid contact of water or organic solvents with the sprayer or the charging unit. The TLC Sprayer meets all relevant safety regulations as EEC safety regulation 82/499; VDE (Assoc. of German Engineers) spark protection 0871-B. - Page 9 Notes: __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________...