Electrolux HKK670MF User Manual page 15

6.4 FlexiBridge Max Bridge mode
To activate the mode touch
the correct mode indicator
connects all sections into one cooking zone.
To set the heat setting use any of the two
control bars on the left side.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected sections. If
you use cookware smaller than three
sections the control bar blinks and after 2
minutes the zone switches off.
Incorrect cookware position:
until you see
. This mode
6.5 PowerSlide
This function allows you to adjust the
temperature by moving the cookware to a
different position on the induction cooking
area.
The function divides the induction cooking
area into three areas with different heat
settings. The hob detects the position of the
cookware and adjust the heat setting
corresponding with the position. You can
place the cookware in the front, middle or
rear position. If you place the cookware in the
front you get the highest heat setting. To
decrease it, move the cookware to middle or
rear position.
Use only one pot when you
operate the function.
If you want to change the heat
setting, lift up the cookware and
place it on a different zone.
Sliding the cookware can cause
scratches and discolouration of
the surface.
• 160 mm is the minimum bottom diameter
of the cookware for this function.
• If you place the pot in the front position,
lights up on the control panel. The
control bar displays the default heat
setting .
ENGLISH 15