How To Use Remote Controller - Toshiba RAV-GM1101KRTP-E Owner's Manual

7

HOW TO USE REMOTE CONTROLLER

Cooling/heating/fan only operation
Start
SWING
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool , Heat
3
Temperature button (
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of LOW
MED , MED
+
OPERATION lamp on the display panel
of the indoor unit goes on. And operation starts
after approximately 3 minutes. (If you select FAN
ONLY mode, the unit will start immediately.)
: Fan only mode does not control
temperature.
is the same as
HIGH .
Therefore, perform only steps
select this mode.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with
a cooling only outdoor model outdoor unit,
appears on the remote controller but the heating
operation is disabled.
1
3
2
4
FAN
)
, or Fan only .
)
, LOW ,
+
, HIGH .
1 2 4
, and to
)
Dry operation
Start
SWING
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Dry .
3
Temperature button (
Set the desired temperature.
OPERATION lamp on the display panel
of the indoor unit lights, and operation starts after
approximately 3 minutes.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
- 18 -
1
3
2
FAN
)
)
.
)
18-EN