Care And Cleaning - GE AKLK08 Owner's Manual & Installation Instructions

Using the Air Conditioner
Air Direction
Tilt the louver bank to adjust up and down.
the beep function by the user. Beep will be active when
Sound ON. Beep will be unfunctional when Sound OFF.
Pressing and holding Filter button for 3-5 seconds to
switch Sound function. Beep will be unfunctional when

Care and Cleaning

Grille and Case
Turn the air conditioner off and remove the plug from the
wall outlet before cleaning.
Air Filter
The air filter behind the front grille should be checked and
cleaned at least every 30 days or more often if necessary.
To remove:
Open the inlet grille by pulling downward on the tabs at
the top upper corners of the inlet grille until the grille is in
a 45º position. Remove the filter.
Clean the filter with warm, soapy water. Rinse and let the
filter dry before replacing it. Do not clean the filter in a
dishwasher.
Outdoor Coils
The coils on the outdoor side of the air conditioner should
be checked regularly. If they are clogged with dirt or soot,
they may be professionally cleaned.
How to Insert the Battery in the Remote Control
1. Remove the battery cover by sliding it according to the
arrow direction.
2. Insert new battery, making sure that the (+) and (–) of
battery are installed correctly.
3. Reattach the cover by sliding it back into position.
49-5000524 Rev. 0
Sound OFF. When Beep ON, it will beep one time. When
Beep OFF active, it will beep three times.
Default Setting
The Default setting for this function was Sound ON.
access to prior setting when power outage recovered.
To clean, use water and a mild detergent. Do not use
bleach or abrasives.
CAUTION
DO NOT operate the air conditioner
without a filter because dirt and lint will clog it and reduce
performance.
NOTES:
system is not going to be used for a long time.