Monessen Hearth Artisan AVFL Series Owner's Manual page 16

Installation of Remote Control Housing
CAUTION! Risk of Fire! DO NOT install damaged or
modified components Warranty will be voided if damaged
.
or modified components are installed.
Kit components: One remote control, two #6 screws, two
wall anchors and 3 AAA batteries. If batteries are properly
installed the remote will turn on
1. Remove remote control components from packaging.
2. Remove battery cover from the back of the remote by
sliding it down and install 3 AAA batteries.
To prevent unintended operation when not using your
heater for an extended period of time (summer months,
vacation, trips, etc):
• Remove batteries from remote control.
• Remove batteries from battery pack.
3. Secure the remote control housing on a flat wall sur-
face using the two screws and wall anchors provided.
See Figure 4.2.
Figure 4.2. Mounting Remote Control Housing
4. Place remote control inside housing. See Figure 4.3.
Figure 4.3. Remote in Housing
5. Close the housing door. See Figure 4.4.
16 Monessen • AVFL Series Owner's Manual • 4099-900 Rev. C • 06/21
Figure 4.4. Mounting Remote Control
Programming the RC300 to the Control Module
CAUTION! Risk of burns! DO NOT program the remote
control to the control module when heater is hot.
• Verify the ON/OFF/REMOTE switch is in the REMOTE
position. Green LED light will blink three times and wall
switch will beep once 5 seconds later when ready. See
Figure 4.5.
• Using a small item (such as a paper clip) press and
release the LEARN button located near the ON/OFF/
REMOTE switch. See Figure 4.5.
• Control module will beep once and LED will blink green
for 10 seconds.
• While the LED is blinking, press the POWER button on
the remote control. A double beep will come out of the
control module to indicate that it has been programmed
successfully.
NOTICE: Up to three remote controls can be programmed
into the control module. Simply press a button on the other
remote controls during the 10 second programming process
to add another remote into the system. It is recommended
to program only one RC300 remote control.
To clear memory in the control module, use a small item
(such as a paper clip) to press and release the LEARN
button. Control module will beep once and LED will blink
green for 10 seconds DO NOT press any buttons on the
remote during the ten seconds that the green LED blinks.
The memory will be cleared. Note that the RC300 will not
be programmed if it's in STANDBY mode. Press the ON/
OFF button twice to switch to IDLE mode.
REMOTE POSITION
Figure 4.5. Programming RC300
Housingng