Power Switch - Yamato SG 710 Instruction Manual

99524
5. Plug in power cord to operate tool.
6. Operate the contrary to the above steps to disassemble blade.
WARNING! Before plugging in power cord, always pull on the blade to make sure it is securely locked in
the clamp. Failure to do so may result in serious injury.
Operation
Power Switch and lock-on Button:
To start saw, squeeze Power Switch with finger. More switch travel will achieve higher speeds. The maximum
speed can be adjusted with the Variable Speed Switch. (Figure 3) To maintain a certain speed, follow the previous
instruction and engage the lock on Button. To disengage Lock-on Button, simply squeeze the Power Switch to
release.
Power
switch
General Cutting:
Hold your saw firmly in front and clearly away from you. Make sure saw blade is clear of any foreign material
and that power cord and extension cord are out of the blade path. Be sure material to be cut is held firmly. Small
work pieces should be securely clamped in a vice or with clamps to the work bench or table. Mark the line of cut
clearly. Pull in the power switch to start the cutting action. Set the shoe on the work. DO NOT FORCE. Use only
enough pressure to keep the saw cutting. Allow the blade and saw to do the work.
Plunge Cutting:
Clearly mark the line of cut. From a convenient starting point within the cut out area, place the tip of the blade
over that point with saw parallel to the line of cut. Slowing lower the saw until the button edge of the shoe rests on
the workpiece. Start the saw and allow it to attain full speed. With the saw resting on the shoe, slowly let the saw
forward to lower the blade onto the cut line. Continue this motion until the saw blade is perpendicular to the
workpiece.
Lock
button
19