Kenmore 625.384200 Use & Care Manual page 18

4. Press SELECT again to display the "97%" screen.
97% FEATURE: The 97% Feature can save salt and
water by regenerating when 97% of the softener's
capacity has been used up. With this feature ON,
the regeneration can occur at any time (whenever
the system has reached 97% of its capacity). The
default is OFF. If this feature is desired, turn it on by
r
pressing the UP button.
5. Press SELECT again to display the "12 or 24 hr"
screen.
12 OR 24 HOUR CLOCK: All time displays are shown
in standard clock time (1 to 12 AM; and 1 to 12 PM)
at the 12 hr default setting. If 24 hour time format is
desired, set to 24 hr by pressing the
Questions? Visit www.kenmorewatersolutions.com or call 1-800-695-2761.
18
Controller Features
6. Press SELECT again to display the "Gallons or Liters"
Figure 29
7. Press SELECT again to display the "Recharge Days"
Figure 30
r
UP button.
screen.
GALLON OR LITER READINGS: Water usage and
flow rate displays are shown in gallons at the default
setting. If you prefer liters, change this setting from
"Gals" to "Liter" by pressing the
screen.
MAXIMUM DAYS BETWEEN REGENERATIONS: The
electronic controller automatically determines regen-
eration fre quency. This provides the greatest operat-
ing efficiency and, under most conditions this feature
will be left in its default mode. However, you can set
this feature to force a regeneration every set number
of days. You may want to do this if, for exam ple,
your water supply contains iron and you want the
softener to regenerate at least once every few days
to keep the resin bed clean. Use the
DOWN buttons to change the number of days (up to
15). If no change is desired, continue to next step.
Figure 31
r
UP button.
Figure 32
r s
UP or