Packing List - Husqvarna Weed Eater WE18C Operator's Manual

ASSEMBLY INSTRUCTIONS
UNPACKING
This product has been shipped completely assembled.
• Carefully remove the product and any accessories from the box. Make sure that all items listed in the
packing list are included.
• Inspect the product carefully to make sure no breakage or damage occurred during shipping.
• Do not discard the packing material until you have carefully inspected and satisfactorily operated the
product.
• If any parts are damaged or missing, please call 11-3868-5000 for assistance.

PACKING LIST

• Lawn mower
• Side discharge chute
• Owner's Manual
WARNING
If any parts are damaged or missing, do not operate this product until the parts are replaced. Failure to
heed this warning could result in serious personal injury.
WARNING
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING
Do not attempt to modify this product or create accessories not recommended for use with this
product. Any such alteration or modification is misuse, and could result in a hazardous condition leading
to possible serious personal injury.
WARNING
Do not allow familiarity with this product to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses with side shields when operating power tools. Failure
to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
WARNING
Do not use any attachments or accessories not recommended by the manufacturer of this product. The
use of attachments or accessories not recommended can result in serious personal injury.
ASSEMBLING THE HANDLE (See Figure 3-4)
• Remove any packing material which may be between the upper and lower handles for shipping
purposes.
• Pull up and back on the upper handle to raise the handle into the operating position. Make certain
the lower handle is seated securely into the handle mounting bracket (see Fig. 3).
• Align the holes (3) between the upper handle (1) and lower (2) handles. Insert the cam locks (4) and
tighten them with the wing nuts (5) provided.
• Secure the lower handle to the bracket with the knob (6) in each side (see Fig. 4).
ENGLISH - 3