Safety READ AND FOLLOW the pump to cycle and lead to pump damage. This may require a larger pressure tank than is normally used. SAFETY INSTRUCTIONS! This is the safety alert symbol. When you see this California Proposition 65 Warning symbol on your pump or in this manual, look for one of This product and related accessories the following signal words and be alert to the potential...
Installation INTRODUCTION PRE-INSTALLATION Pentek CSC Control and Monitoring System provides DANGER! EXPLOSION HAZARD. When the control of high voltage (120/240 VAC) pumps. Pump well tank has been in service and a change to a higher pre- operations can be controlled through a mobile device or charge pressure is necessary due to a required change in computer.
Page 4
Installation For best ground connection, connect to grounded lead in service panel or to metal underground water pipe or well casing at least 10 ft. long. If plastic pipe or insulated Ground fittings are used, run ground wire directly to metal well Connection casing or use ground electrode furnished by the power company.
Page 5
Installation Pair the Pentek CSC with Smartphone/Tablet or Computer Disconnect power to the Pentek CSC device for 10 seconds, and then return power to the unit to activate local access or connection mode. 2. Wait until the Communication LED on the device is be Blinking Blue. This step could take up to 5 minutes.
Installation Connect Pentek CSC to Home WiFi Disconnect your smartphone/tablet or computer from the device WiFi. Open your smartphone or tablet WiFi settings. To open WiFi Settings on smartphones or tablets: Go to Settings>WiFi or Settings>Connections>WiFi. To open WiFi Settings on computers: Click on the WiFi icon [ ] in the desktop system tray.
Troubleshooting The unit is indicating that it is not connected to any WiFi and is searching for the home network(s) stored in Solid Red the device during setup. The unit is scanning for available WiFi networks. The networks found during this step populate the SSID drop Blinking Red down during the setup process.
Troubleshooting Fault Codes FAULT TRIGGER POSSIBLE CAUSES POSSIBLE SOLUTIONS Check line to line resistance (Ohms) and Shorted motor wires - line to line confirm they match motor specifications. The device is behaving like and (Rx1 scale) ammeter and indicating that Over Current it is drawing greater than the Damaged wire insulation.
Warranty Limited Warranty STA-RITE® warrants to the original consumer purchaser (“Purchaser” or “You”) of the products listed below, that they will be free from defects in material and workmanship for the Warranty Period shown below. Product Warranty Period whichever occurs first: Water Systems Products —...