Roland JX-8P Vecoven PWM Installation Manual page 7

Remove the nine screws indicated and carefully lift the main board out and place on an appropriate,
electrostatically protected work surface.
NOTE:
Task Order
There is no set order to the following tasks. The order set out in this guide is merely how this particular
installation was completed.
De-soldering / Use of Sockets
A very high quality de-soldering tool was used to perform the installation described in this guide and is
strongly recommended. However it is recognised that the installer will use their own skills, methods and
equipment to carry out the tasks as well as decide upon the use of sockets.
7