LG WT19WS6 Owner's Manual page 33

Connecting the Drain Hose
Before connecting Drain Hose, check your Drain Hose model and choose the correct instructions.
Pump Model
Insert the plastic holder into hole
in the back side toward the stand
pipe direction. Adjust the holder
by pressing the both sides to
push in.
Push the end part of the drain hose in the
outlet of the drain pump and tighten with
2
the clamp to fit in.
Insert the open end of the drain hose into the standpipe
or wash tub. To prevent the hose from dislodging and
3
falling. Fit the curved holder to the hose and secure it
to the stand pipe or laundry tub.
Caution
• The outlet should be placed 0.9-1.2m higher than the floor.
• To prevent siphon, the drain hose should not be extended more
than 50mm from the end of the hose guide.
• The hanging down drain hose might cause poor drainage.
Non-Pump Model
Push the elbow hose toward the body of the wash-
Connect the Elbow Hose
ing machine.
2
To change the direction of the hose, pull out the
Place the Drain Hose
elbow hose and change the direction.
Repeat Step 1.
Holes
For Holder
Holes
Bottom
For Holder
Holes
For Holder
Holes
For Holder
Within 50 mm
0.9-1.2 m
Within 50 mm
Hose
Guide
0.9-1.2 m
Within 50 mm
0.9-1.2 m
Within 50 mm
0.9-1.2 m
Bottom
Bottom
Bottom
Hose
Guide
Hose
Guide
Hose
Guide