Mitsubishi Electric EHPT20Q-VM2EA Service Manual page 15

9-2. Setting the Main Controller
After the power has been connected to the outdoor and cylinder units (See chapter 7) the initial system settings can be entered via the main controller .
one minute whilst the control menus load.
5. Press button E (Power) (refer to page
9-3. Main Settings Menu
two access levels to the main settings; and the service section menu is password
protected.
User Level – Short press
displayed but without the edit function. This will enable the user to view current
settings but NOT change the parameters.
Installer Level – Long press
with all functionality available.
The following items can be viewed and/or edited (dependent on access level).
Main menu
Long Press
General Operation
.
15
GCH15010