Clutch - Husqvarna K970 SmartGuard Workshop Manual

d) Put in the 7 screws before the crankcase halves
are put together. This helps put the gasket into
position.
7. Tighten the screws around the crankshaft in correct
order, refer to the illustration, torque 10–11 lbf·ft/14–
15 Nm. Make sure that the crankshaft moves freely
after it is assembled. Hit the ends of the shaft with a
small plastic hammer to release tension.
2-8
4-10
8. Cut the gasket at the cylinder face.
Examine the crankcase for leakages after the cylinder is
assembled.
1451 - 001 - 02.04.2020
6-12
3-9
1-7
5-11

6.13 Clutch

6.13.1 To remove the clutch
To remove the clutch, use a Husqvarna piston stop,
Servicing tools overview on page 11 .
refer to
1. Lock the crankshaft with the piston stop.
2. Release the clutch clockwise.
CAUTION: Do not hit the puller, the piston
can break. Do not use a hammer or
equivalent without the piston stop. It can
cause damage to the lock mechanism of the
flywheel slot.
Repair and servicing - 53