Audio Playback - Devolo Audio Extender User Manual

5.1.2

Audio playback

No sound output
Effect:
No sound.
Possible causes:
b
b
b
b
b
b
b
Solutions:
b
b
b
b
b
The volume of your stereo system or active loudspeakers is turned down or
muted.
The audio cable is not plugged in or slipped out.
The audio cable is connected to a different input or an output of your stereo
system or active loudspeakers.
The sound of your computer is turned down or muted, e.g. in the Windows
volume control.
The sound output was not switched to the dLAN Audio extender, but is still
switched via the PC sound card.
The dLAN is not correctly configured.
The transmission speed in the dLAN is too slow.
Turn the volume higher at the output device or switch muting off.
Check whether the audio cable is plugged into the correct sockets at both
ends.
In Windows XP, call up the volume control via start
Sounds and Audio Devices
Ensure that both Volume Control and Wave are not turned all the way
down and that the Mute check boxes of these two channels are not dis-
abled.
Check whether the devolo dLAN Audio extender Control software is
loaded (identified by an icon consisting of a note with a loudspeaker in the
Windows system tray at the bottom right on the taskbar) and the output is
redirected to the devolo Audio extender sound driver (right-click on the
application icon, then Select default audio device).
Check whether your dLAN functions properly.
! !
Volume Device volume
|
devolo dLAN Audio extender
|
31
Appendix
! !
Control Panel
!
Advanced.
|