Power On Command - Denon DCM-390 Specification

Revision1.30
Date 25.Apr.'06

2.6. 21 Power ON command

This command releases the "Stand-by" status.
After "Power ON" command the device will do some operations for reset and return Answer code.
At last the device resets itself.
1) Command format
Byte/bit
0
1
2
3
4
5
6
7
8
2) Answers returned
Byte/bit
0
1
2
3
4
5
3) Special condition
- This command accepts only "Stand-by" status.
- This device cannot receive any commands within 2 seconds after this command is sent.
- After Power ON command, the host shall wait the device becomes ready status. The device returns not
Ready status for Request Status command before get ready.
D&M
7 6 5
Table 61. Power ON command
7 6 5
Table 62. Power ON answer
DCM390 Serial Interface Specification
4 3 2
STX (0x02)
Command code ('N')
Reserve (0x00)
Reserve (0x00)
Reserve (0x00)
Reserve (0x00)
ETX (0x03)
BCCH (high-level)
BCCH (low-level)
4 3 2
STX (0x02)
Reply code ('N')
Answer code (Table 3)
ETX (0x03)
BCCH (high-level)
BCCL (low-level)
39 page of 40
1 0
1 0