Using The Light Off Function; Using The Auto Clean Function - LG VW182CE ST0 Owner's Manual

18 OPERATION
Clean Filter
6
The Clean Filter (Limpiar filtro) LED lights
up to notify you that the filter needs to be
cleaned. After cleaning the filter, press
Temp and together on the control
panel to turn off the Clean Filter (Limpiar
filtro) light.
NOTE
● The filter reset must be done using the
control panel, not the remote control.
● This feature is a reminder to clean the air
filter for more efficient operation. The LED
light turns on after 250 hours of operation.
Fan Speed
7
Press to set the Fan Speed (V.vent) to
Low (Bajo) (F1), Medium (Medio) (F2) or
High (Alto) (F3).
Temperature Control
8
The thermostat monitors room temperature
to maintain the desired temperature. The
thermostat can be set between 16 °C–30 °C
(60 °F–86 °F). Press
increase or decrease temperature setting.
Energy Saver
9
In this mode the compressor and fan turn
off when the set temperature is achieved.
Approximately every 3 minutes the fan turns
on to allow the unit sensor to accurately
determine if more cooling is needed.
Clear
10
Cancel Sleep and Timer settings. Also set
the Diagnosis if held for 5 seconds.
NOTE
● Auto Restart: If the air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
● Energy Saver (AA.Energía) : The unit defaults to
the Energy Saver (AA.Energía) mode each time the
unit is switched on except in Fan (Vent.) mode or
when power is restored after an electrical power
outage.
● The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.

Using the Light Off Function

You can set the brightness of the control panel,
●
Press
3 seconds, or
● Press
the control panel.
NOTE
●

Using the Auto Clean Function

In the Cooling and Dry Mode, Moisture is
generated inside the indoor unit. This function
removes such moisture.
●
Press
control for 3 seconds.
●
NOTE
●
or arrows to
Mode
button on the remote control for
Modo and Dormir button together on
Turn on/off the control panel.
Energy Saver
button on the remote
is displayed on the remote control.
If you turn off the unit, the fan continues to run
for 10 minutes and cleans the inside of the
indoor unit.