Installation Of The Cabinet; Space For Outside Air Flow - LG VW182CE ST0 Owner's Manual

Installation of the Cabinet

1
Prepare the hole in the wall so that the
bottom of the cabinet is well supported,
the top has minimum clearace and the
air inlet louveres have clearance as
shown. Holes from the outside through
to the cavity should be sealed. The
cabinet should slope down towards
the rear by about 10~15 mm to allow
water formed during operation to drain.
2
Install the cabinet into the wall and
secure. Ensure the foam seals are not
damaged. Flash, seal or fill gaps around
the inside and outside to provide
satisfactory appearance and protection
against the weather, insects and rodents.
NOTE
● Unit may be supported by a solid frame from
below or by a hanger from a solid overhead
support.
FLASH OR SEAL AROUND EXTERNAL
WALL FRAME OR ARCHITRAVE
STURDY TIMBER
EXTERNAL SUPPORT
FRAME ALL ROUND
FRAME AT BALANCE
UNIT
POINT OF RAC
ALTERNATIVELY, BRACKETS
TIMBER FRAMED AS ILLUSTRATED BELOW
WALL OR PARTITION MAY BE USED.
Preferred method of installation into
a timber framed wall, partition or window.
DRAIN CHUTE

Space for Outside Air Flow

AIR IN
AIR OUT
100 mm minimum
OPTION A
45° BRICK CUT AWAY
TO CLEAR LOUVRES
FRONT
BRICK
WALL
100 mm
TOP
VIEW
AIR IN
LOUVRE
AIR OUT
OPTION B
EN
INSTALLATION 15
AIR IN
45° BRICK CUT AWAY
TO CLEAR LOUVRES
170 ~ 270 mm
BRICK
WALL
AIR IN
100 mm